Ethanoic acid was added in drops to water and it was noticed that:
(1) the acid formed a separate layer on the top of water (2)water formed a separate layer on the top of the acid
(3)a clear and homogeneous solution was formed (4)a pink and clear solution was formed
"

Correct answer: (3) a clear and homogeneous solution was formed

Explanation: Ethanoic acid was added in drops to water and it was noticed that a clear and homogenous solution was formed due to the formation of intermolecular hydrogen bonding.

Tutorialspoint

Updated on: 10-Oct-2022

82 Views

While diluting an acid, why is it recommended that the acid should be added to water and not water to the acid?
5 mL of dilute acetic acid were added to 5 mL of water and mixture was shaken for one minute. It was observed that :(1)the turbidity appeared in the test tube(2)the acid formed a separate layer at the bottom(3) water formed a separate layer at the bottom(4)a clear solution was formed
Vinegar is a solution of about:(a) 5 to 8 percent ethanoic acid in alcohol (b) 5 to 8 percent ethanoic acid in water (c) 50 to 80 percent ethanoic acid in water (d) 50 to 80 percent ethanoic acid in alcohol
What was the name of JavaScript when it was created?
Two drops of dilute sulphuric acid were added to 1 g of copper sulphate powder and then small amount of hot water was added to dissolve it (step 1).On cooling, beautiful blue coloured crystals got separated (step II). Step I and Step II arephysical and chemical changes respectivelychemical and physical changes respectivelyboth physical changeboth chemical change.
A soil sample was taken by Boojho, from agricultural land and was weighed. The mass of the soil was found to be 40g. 80 mL of water was taken in a measuring cylinder and added to the soil sample. The soil absorbed 60 mL of water and the rest left in the measuring cylinder. Calculate the absorption rate of water by the soil.
Mean of 9 numbers was found to be 89. Later on it was detected that one number 81 was misread as 18 . Find the correct mean.
Iron fillings and sulphur were mixed together and divided into two parts, 'A' and 'B'. Part 'A' was heated strongly while Part 'B' was not heated . Dilute hydrochloric acid was added to both the Parts and evolution of gas was seen in both the cases. How will you identify the gases evolved?
2 mL of ethanoic acid was taken in each of test-tube I and test-tube II. A red litmus paper was introduced in test-tube I and a pH paper was introduced in test-tube II. The experiment was performed by four students A, B, C and D, they reported their observations as given below :
It was found that water from a river was contaminated with Coliform bacteria. Which one of the following pollutant might have got mixed with the water?Fertilizer run offIndustrial wastePesticidesHuman faecal matter
(a) While diluting an acid, why is it recommended that the acid should be added to water and not water to the acid?(b) Dry hydrogen chloride gas does not change the colour of dry litmus paper why?
From a tank, completely filled to its brim, water equal to $\frac{2}{5}$ of its capacity was taken out. 130 litres of water was added to the tank leaving it only $\frac{1}{6}$ empty. Find the capacity of the tank.
What happens when an acid is slowly added to water?
Iron powder and sulphur powder were mixed together and divided into two parts A and B. When part A was heated strongly over a burner, then a substance C was formed. The part B was, however, not heated at all. When dilute hydrochloric acid was added to substance C, then gas D was evolved and when dilute hydrochloric acid was added to part B then gas E was evolved.(a) What type of substance is B?(b) What type of substance is C?(c) Name the gas (i) D, and (ii) E?(d) State one characteristic property of gas D.(e) Write one test to identify gas E.
Yesterday I was pouring hot water in a glass cup and it shattered. Can you explain why is it so?

Kickstart Your Career

Get certified by completing the course

Get Started

(1) the acid formed a separate layer on the top of water	(2)water formed a separate layer on the top of the acid
(3)a clear and homogeneous solution was formed	(4)a pink and clear solution was formed

Ethanoic acid was added in drops to water and it was noticed that:(1) the acid formed a separate layer on the top of water(2)water formed a separate layer on the top of the acid(3)a clear and homogeneous solution was formed(4)a pink and clear solution was formed"

Kickstart Your Career

Ethanoic acid was added in drops to water and it was noticed that:
(1) the acid formed a separate layer on the top of water (2)water formed a separate layer on the top of the acid
(3)a clear and homogeneous solution was formed (4)a pink and clear solution was formed
"